Recent Posts

Categories

Search Site Blog

 

security system alarm

Basic DIY home security systems start at about $225 and top out at $800 or so. If you add wireless smoke/heat detectors, plan to spend about $1,300 for DIY alarm systems. That’s about half of what a professional alarm company would charge. Monitoring service, which notifies the police or fire department, can cost $40 or more per month. But if you shop around, you can get it for about $10 per month. Some alarm installers recommend eliminating window transmitters and installing motion sensors instead.

Posted by Anonymous at 3:19PM | (3 comments)

security alarm systems for homes

Install a home alarm system: While an alarm may not keep burglars from getting inside your home, it will deter some and bring the police to your home quickly, limiting what a thief is able to take. Home security systems will only work if you always remember to engage the alarm. You should have your alarm engaged while you are away or while you are at home as many thieves will attempt to break into one part of your home while you are busy in another. Also, some insurance companies may lower your home insurance premiums for having a home alarm system installed. ADT provides customers with a few methods to help them balance out the price of its products and services. The Homeowner’s Insurance Certificate can save customers substantially if their homeowners insurance provider offers premium discounts for installing a home security system. The Mover’s Saving Package provides discounts for customers who have been with ADT for six months and are moving into a new home. Along with these discounts, customers can also get 25% off additional sensors up to a maximum of $749. Considering the high price of installing ADT systems, this is a good way to save money. DIY home security systems have no installation fees and cost much less than traditional systems, as you set the system up yourself. Since you have the freedom to install it whenever you want, there’s no need to schedule an appointment and wait for a technician.

Posted by Anonymous at 3:19PM | (8 comments)

alarm systems house

Clumsy shop vac hoses usually cannot effectively clean through most furnaces burners, hence the ash, dirt, carbon and dust that can be found in these burners typically stay in the burners. This results in no efficiency improvement when cleaning out the burners, because the shop vac hose could not fit inside of the burners to properly clean it as compressed air or nitrogen can. Most ventilation and or HVAC systems have portions of ductwork that is not easily accessible due to portions of the ductwork being drywall finished around. Should this be the case at any given jobsite, a consumer and or customer must realize that a large portion of ductwork will not be cleaned as a result when the contact cleaning method of air duct cleaning is employed. Typically a shop vac hose can only reach up to 15’ before the hose just curls up. Some trunk lines may stretch out to over 100’ in distance, which means 15’ would be cleaned and 85’ would go untouched. 90 degree turns will almost always make the shop vac end its descent in cleaning down a pipe because the shop vac hose cannot be turned without physical intervention. A greater risk of disconnecting pipes occurs due to the physical nature of the contact cleaning method. Also if any home security wiring, telephone wires or low voltage wiring is ever present in the ductwork, the physical nature of the contact cleaning method in air duct cleaning will increase the chances in breaking such wires, whereas air washing will not compromise such wires in any shape way or form. Most contact cleaning companies will recommend that you should have your air ducts cleaned out every year or two, because they know they left enough debris in the ductwork to try to get at it again in a year or two. Well there you have it folks.

Posted by Anonymous at 3:19PM | (3 comments)